Great-planes ElectroStik EP RxR - GPMA7500 Manuale Utente

INSTRUCTION MANUALWingspan: 52.75 in [1340mm]Wing Area: 589 in2 [38dm2]Weight: 3 – 3.5 lb [1360 – 1587g]Wing Loading: 11.7 – 13.6 oz/ft2 [36 – 42g/dm2

10❏ 8. Connect both the elevator and rudder pushrods to their control horns. Use the third-from-the-inner hole in the control horn for both pushrods t

11❏ 5. Secure the wing by inserting the two 10-24 nylon wing bolts into the wing and tightening them down as shown.❏ 6. Now is a good time to test th

12Set the Control ThrowsTo ensure a successful fi rst fl ight, fl y your ElectroStik EP RXR set up only according to the C.G. and control surface throws

13PREFLIGHTIdentify Your ModelNo matter if you fl y at an AMA sanctioned R/C club site or if you fl y somewhere on your own, you should always have your

14LITHIUM BATTERY HANDLING & USAGEWARNING!! Read the entire instruction sheet included with your battery. Failure to follow all instructions could

159) Under no circumstances may a pilot or other person touch a powered model in fl ight; nor should any part of the model other than the landing gear,

FlightFor reassurance and to keep an eye on other traffi c, it is a good idea to have an assistant on the fl ight line with you. Tell him to remind you

2TABLE OF CONTENTSINTRODUCTION ... 2AMA ...

3We, as the kit manufacturer, provide you with a top quality, thoroughly tested kit and instructions, but ultimately the quality and fl yability of you

Optional Supplies & ToolsHere is a list of optional items mentioned in the manual that will help fi nish the ElectroStik EP RXR. Order numbers are

5Replacement Parts List Description How to PurchaseMissing pieces Contact Product SupportInstruction manual Contact Product SupportFull-size plans

6KIT INSPECTIONKIT INSPECTIONBefore starting to build, take an inventory of this kit to make sure it is complete and inspect the parts to make sure th

7PREPARATIONSUse a covering iron with a covering sock on medium/high heat to tighten any loose covering if necessary. Apply pressure over sheeted area

8❏ 5. Connect both servos to the “Y” harness. Make sure the “Y” harness exits through the hole in the center of the wing. Use the strings pre-install

❏ 3. Put the tail gear bracket in place as shown and secure the entire tail assembly with a #2 lock washer and 2mm nut on each bolt. Be certain to tig